BSI 108 Insta-Cure+ Medium CA 2oz nat_Israel Softens and removes paint from

Softens and removes paint from plastic in minutes

Use them individually or in combination for a variety of effects nand transitions

‘Regular ALCLAD’ is similar in strength to lacquer/cellulose car paints-injected polystyrene plastics frequently have areas which ALCLAD can craze

Included with each model are a full set of easy-to-follow colour instructions

2nd in the 5 inch saucer series

BSI 108 Insta-Cure+ Medium CA 2oz nat_Israel Softens and removes paint fromInsta Cure+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, INSTA CURE+ should also be used. To prevent premature curing, dont spread the glue into a thin film. Lay down a serpentine bead with about 1"