Belt Set Compatibility:Ultra One (MG20TB) 5 - Stepper motor drivers

5 - Stepper motor drivers

Printer Setup

the electronics board is crucial to the operation of the M Series printers

Please note: This board ships with Rev H firmware

Published design files for the MakerGear M3 printer

Belt Set Compatibility:Ultra One (MG20TB) 5 - Stepper motor driversBecause they are kevlar reinforced, it is very rare for the belts on MakerGear 3D printers to be damaged. If your belts are worn, check your printer for alignment issuesmisalignment is the most likely cause for worn belts, and should be addressed in order to maximize the lifetime of your belts. The M2 belt set includes both belts used on the M2 and M3 SE rev 0 3D printers (630 mm for the X axis and 702 mm for the Y axis). The M3 SE belt set includes