Howe Easy Adjuster Weld-On Sway Bar Adjuster - 7/8-9 in Thread - Up to 1-1/2 in Sway Bar 711021 Flat bottom design works with

Flat bottom design works with 5" or 5-1/2" conventional springs which must be mounted with the closed end seated in the control arm and the open end in the upper spring cup or a spring ramp (sold separately) may be welded onto the lower plate to place the open end down

Zeon 12 Platinum

The ATI Crank Pin Drill Fixture Kit allows you to install 1 or 2 dowel pins to the LS1 or HEMI crank

Part Number: 241-281

100 Percent Tig Welded For Strength And Durability

Howe Easy Adjuster Weld-On Sway Bar Adjuster - 7/8-9 in Thread - Up to 1-1/2 in Sway Bar 711021 Flat bottom design works withAdjusting the sway bar pre load has always seemed to be a bigger job than it should be. You have to jack up the car, turn the wheel, loosen one jam nut and tighten the other. Now there is a better way. This adjuster is simple to install and use. One will fit easily on any chassis. No need to jack up the car. To adjust, use a 3 8" drive wrench on the top and simply turn in or out to pre load. a thread drag adjuster prevents it from moving on its own.